PDA

View Full Version : Anyone have a AOD stall converter??

BAD BOB
01-20-2009, 02:37 PM
Im looking for a stall converter for my fox. Let me know
Darryl Buckner
01-20-2009, 03:26 PM
I believe I have a stock one..
BAD BOB
01-20-2009, 04:15 PM
there is a stock one in it now i need one with a higher stall so i can launch harder
LXtasy
01-20-2009, 05:41 PM
do you need a lock up or non?
Darryl Buckner
01-20-2009, 06:09 PM
Send the stocker to Mr Cameron and let him loosen it up. He changed the stocker in the Mach 1 to 2700rpm, for about $150.00..
LXtasy
01-20-2009, 06:14 PM
i have a non lockup aod converter 2800 stall here. NEVER USED. Bought for my fox but was wrong converter.
BAD BOB
01-20-2009, 09:19 PM
i have a non lockup aod converter 2800 stall here. NEVER USED. Bought for my fox but was wrong converter.

I dont know what i need. But depending on what you want for it and if it will work then we might be able to work something out with your exhaust work
LXtasy
01-20-2009, 09:57 PM
I will throw it in the truck and you can see.
BAD BOB
01-20-2009, 10:01 PM
is it a lock up or non?
LXtasy
01-20-2009, 10:13 PM
I believe non lockup. But quite frankly I am not sure. We tried to install it in my fox. but it wouldn't work with the transmission setup I ended up going with. Custom built aod w/ 4r70w gearset, transgo kit, wide ratio planetaries, etc etc. I will have to DIG for the receipt to see which it was for and what I actually needed. This was almost 2 years ago. I know I paid $285 for it than. Will check real quick
BAD BOB
01-20-2009, 10:18 PM
And do you know what stall it is?
LXtasy
01-20-2009, 10:35 PM
2800-3000 area stall. I could not find any record at all of it. I had a folder of all mustang purchases and it must have been shredded :(
BAD BOB
01-20-2009, 10:45 PM
thats cool. Yeah if you want to set something up let me know. Im interested in getting it and will prolly need it by sometime next week if possible
LXtasy
01-20-2009, 10:49 PM
*crosses fingers* Hopefully we are dropping the truck off to you saturday. Maybe friday. Ran into so many problems last friday that we didn't get it started up until after 7pm saturday night :(

Just buttoning up the little things and putting the front end back together alittle at a time this week. So it should be most likely ready for you for this weekend.
BAD BOB
01-20-2009, 11:01 PM
sounds good